I have a strange problem with my Panasoniy RX-DT9. When the device stands normal horizontal, then the CD starts to spin but does not play. If I skip some songs forward, then sometimes the music starts, but often is looping or even jumping back. But if I tilt the device a little bit, then the CD runs from the beginning to end without any problems. Here is a short video: Any idea, what could be the root cause? A wear out in spindle motor bearing?
YES! At least with Sony Discmans this is the first indication that spindle motor is worn to death: plays when at an angle but skips when level. How does it play when upside-down? Sometimes an over-eager fingers push CD platter further down the spindle. But, again, most probably it is the worn spindle motor. Cheap'n'Dirty temp fix would be a droplet of oil, applied with a needle/syringe onto motor shaft under the platter. If motor has hole(s) for the bottom bushing, then some oil goes there too: New motor (Mabuchi motors with different shaft lengths available from eBay, some even with a platter as this above) should fix the problem permanently. Contact me or kaosuncd.com on how-to: it is a bit tricky but not too difficult
Hello Jorge, thank you very much for your advise. This is very helpfull. I will try at first the droplet of oil. But in any case I will order also a new motor as it is so cheap. The RX-DT9 is in any case worth to keep it running. Would contact you, if I need further help for motor replacing.