Tascam DP-01 FX/CD - Power Off

Discussion in 'Tech talk' started by TK421, Feb 14, 2021.

  1. TK421

    TK421 Member

    Messages:
    40
    Trophy Points:
    8
    Location:
    Paris
    Hi everyone,
    My Tascam DP-01 FX/CD has stopped working (sniff). The unit powers on (power light comes on) but no display or functions available. I’ve had it in storage for a while and lost the original power supply. I used a generic 12v power supply but that shouldn’t be a massive issue, right?
    Anyone have any ideas?
    Tx
     
  2. Michelle Knight

    Michelle Knight Active Member

    Messages:
    410
    Trophy Points:
    43
    Location:
    Sussex, UK
    Check the amps it's pulling/providing? If the unit needs more amps than the generic power supply is capable of, you might have a problem there.
     
  3. Michelle Knight

    Michelle Knight Active Member

    Messages:
    410
    Trophy Points:
    43
    Location:
    Sussex, UK
    It looks like 2.5A with centre pin positive.
     
  4. TK421

    TK421 Member

    Messages:
    40
    Trophy Points:
    8
    Location:
    Paris
    The replacement ones on the internet say output 12V - 4000mA whereas the one I have says 12V - 100mA so it's probably not getting enough juice.
    Sound right?
     
  5. Michelle Knight

    Michelle Knight Active Member

    Messages:
    410
    Trophy Points:
    43
    Location:
    Sussex, UK
    Yeah, that sounds just about right. Not enough mA, by a long shot.
     
  6. TK421

    TK421 Member

    Messages:
    40
    Trophy Points:
    8
    Location:
    Paris
    Thanks Michelle! Hopefully there's still life in the thing yet..
     
  7. Michelle Knight

    Michelle Knight Active Member

    Messages:
    410
    Trophy Points:
    43
    Location:
    Sussex, UK
    The voltage has to be correct.... but the power supply can be, "over amped"... as long as it's not "under amped" so if you get one at 12v 5000mA (or 5A) you should be fine. - So 4000mA (milli-amp) is also 4A. (amp)
     

Share This Page