AIWA HS-JX505 - did I kill the amp with a short-circuit in the headphone cable?

Discussion in 'Tech talk' started by jonas, Nov 8, 2022.

  1. jonas

    jonas New Member

    Messages:
    14
    Trophy Points:
    3
    Location:
    Berlin
    Hi, I posted this earlier this evening over at tapeheads-forum, but get no replies yet.
    Therefore I try it again here and hope someone can help.


    I have just recapped an AIWA HS-JX505 walkman.
    The walkman sounded absolutely fantastic after that. Powerful and crisp and clear.

    Then I have listened to a whole cassette (SONY UCX-S90) with my on-ear headphones
    and was totally thrilled about the sound.

    Unfortunately, after that I wanted to test some old AIWA Pipephone headphones,
    which I had once bought together with another Walkman. But that was a big mistake,
    the headphones had a short circuit in one of the cables (only the left channel worked).

    The whole testing with the defective headphones took maybe 2-3 minutes.
    When I then reconnected my other headphones, the JX505 sounded absolutely shitty.
    Totally distorted on one channel and also the other channel did not sound
    as good as before (very slight distortion).

    I am now totally frustrated and hope that it is somehow fixable.
    Unfortunately my electronics knowledge is not good enough to locate this fault.
    I have made a screenshot of the schematic and hope that one of the walkman experts here
    can give me a hint how to save this walkman.

    will be grateful for any help
    Jonas

    [​IMG]
     

    Attached Files:

  2. Silver965

    Silver965 Well-Known Member

    Messages:
    710
    Trophy Points:
    93
    Location:
    Torino
    Hello and welcome
    if you hear the two channels but in a distorted way i would start checking these ... with the tester check if there is continuity or not

    Aiwa jx 505.jpg
     
    thid likes this.
  3. jonas

    jonas New Member

    Messages:
    14
    Trophy Points:
    3
    Location:
    Berlin
    thankĀ“s Silver for your reply. I will check this and then get back to you.
     
  4. jonas

    jonas New Member

    Messages:
    14
    Trophy Points:
    3
    Location:
    Berlin
    Checked both and both have continuity.
    I checked them on the board, not unsoldered.
    Does that make a difference?
     
  5. jonas

    jonas New Member

    Messages:
    14
    Trophy Points:
    3
    Location:
    Berlin
    Success! Have changed the capacitors C84 and C83 and the good sound is back!
     
    thid, Valentin and Silver965 like this.
  6. Lincoln Scott

    Lincoln Scott New Member

    Messages:
    13
    Trophy Points:
    3
    Location:
    MO
    Glad that you got it going again!!

    I'm currently in the middle of restoring a few of my Aiwa's and wanted to ask where you might be sourcing the capacitors from or if you would even be willing to sell a few that I am in need of to finish up mine?

    Thanks again and super happy to hear that another one has been saved!

    Best regards!
     
  7. jonas

    jonas New Member

    Messages:
    14
    Trophy Points:
    3
    Location:
    Berlin
    Valentin likes this.

Share This Page