The C601 is a 10 nF capacitor, first time I went through the components it measured 8,7 nF. I don't know if that is enough difference to make the...
I started from Q601 transistor and went down the line. I had checked the C601 capacitor previously and it was OKish but decided to check again and...
Here are the measurements from pins 15 → 9: https://imgur.com/a/pin-measurements-8hRlxle I took two measurements of each pin: one with the motor...
Thank you, Valentin! I'll check pins 9–14 so I can see where my waveforms first start to differ.
I took everything apart again and tried to run the motor and capstan without the center gear assembly. I still get a weird vibration from the...
Yes, the clutch and torque seem to be OK. Compared to my other DD units and D6C it seems to be about the same.
Could this be somehow related to an electrical issue? Yesterday I thought I got the problem fixed after adjusting the motor position: the W&F was...
I cleaned the clutch, added the tiniest amount of PDP65 to the plastic ring. Did not help. Shucks!
That is a good point! Haven't thought of that. I will open and clean it. But I should probably get a torque cassette to actually verify it or is...
Yea, no grease. I’ve been really metaculous about cleaning the capstan ring and capstan axle and pinch roller. And I clean them every now and...
Thank you for a reply! Yes, the capstan ring is the fixyouraudio one. I’ve measured the 96mA current from the ideal thrust position, about 0,2mm...
Oh yeah, forgot to mention. The capstan ring is new as well.
The saga continues! Now that the speed issue has been resolved, I replaced all the caps on the audio board, and the DC2 sounds amazing! Well.. it...
Problem solved! I had the other FG coil wire soldered to the wrong pad. There’s three pads next to each other and even though the PCB clearly...
I also measured directly from the FG coil solder pad on the PCB. I get the same strange distorted waveform that can be seen down the path towards...
I repeated the measurement with proper edge triggering and auto mode off. Still looks bad. [IMG] I went down the line and also repeated the...
I rechecked pin 3 with the meter set to AC. The waveform is still clearly distorted and definitely not a clean sinewave....
After this it got me thinking that maybe the coil is in fact defective. I tried changing the the coil from a DD3 which has been proved to be...
I have not check the sawtooth waveform! This is where things start to go above my paygrade :D All I have is a couple of multimeters and I've...
Here's parts I've checked / replaced. CX20084 – replaced with another genuine CX20084 taken from a WM-DD3. (I also tried another one from D3 just...
Separate names with a comma.