Hello Deb64, I am currently preparing to disassemble my WM-D6 to try to solve a fast running on playback problem. When I tried my WM-D6 powered with a correct Sony 6volt power supply it worked OK first time. Second time it was running fast on playback but no other symptom. I am wondering if the complete CP602 is available anywhere. MikeC
Hi Deb, I have a walkman WM-DD, bought new in 1982. It's well used, well loved and I still use it daily. The center gear and pinch roller have been replaced with parts from Marian. It plays well except for stopping while playing, or sometimes playing very fast like a chipmunk. Would you be able to look at this for me?
Hi, I have a WM-DC2 that I've had since new and would like to get it back to how it worked in the 80s. It clicks but everything else seems ok but would like an expert to do everything required for a good refurb. It is in minty condition cosmetically. Many photos in my introduction post. Would you be interested in doing the refurbishment for me? I'm Bristol based.
Ich habe deinen Bericht von dem Sony CF470 L gelesen. Ich habe den Idler Gummi gem. deiner Anleitung gewechselt und davor das den rechten Spulenteller ausgebaut. Nun habe ich ein Problem beim wieder einbauen. Es gibt dort ein weisses Bauteil, wo ein Pin rein gesteckt wird und mir ist der Zusammenbau nicht klar. Ich finde auch nichts im Internet.
Hello, mihokm, i`m Fritz from Dresden, Germany, with a Sony WM-F501 to check . During check i found some little washers flying free in the mechanics, and i haven`t found the place, where they belong. And two washers are missing - from one capstan and the pulley . I found your washers set on your website "fixyouraudio" - will this set be compatible with this items ?Kind Regards
Hey Im curious if you ever figured out your audio issue with the Panasonic rx 5150. i have the same issue and have not been able to figure it out. please let me know if you ever tracked down the cause and were able to fix it.
I have one of these systems with the box. My amp needs a board or repair the board. Any idea how I get this done ?
I have been collecting boomboxes for a while since i was 5 I have recently received a Trident CX473F gold version and I added leds to it.
Hi - I'm wondering about the cost for a refurb of a WM-D6 (ie not the C version)? Yeah, I was hoping that it would be a simple belt, roller etc job that I was putting off - however, whilst it had been playing correctly using an official Sony AC-15A Adaptor, in the middle of digitising a tape then it started speeding up; where it's now playing ludicrously fast - so I'm assuming that it's a CP602 fault. :( Thanks.
