Well, it’s a pity but it’s not the end of the world. It should be fixable. You need some good equipment to remove cp602 without lifting pads. So...
may be a long shot, but there is a switch inside the dc jack that switches between the battery power and the dc input, depending on what is...
A bad pinch roller might be hard with a glazed surface or deformed, or with small cracks. if it’s the original one it’s quite certainly bad by...
Sound like the tape is wandering around messing up the Azimut. You might need to replace the pinch roller and perhaps also adjust the Azimut...
You could trickle charge NiMH the same as NiCd, it would be much slower than an external fast charger but it would work, it's probably the best...
The walkman can charge the BP-23 internally, the middle pin in the battery "receptacle" is the charging pin, it is connected directly the positive...
A good soldering iron with good quality tips, (not necessarily expensive) is mandatory wen working with old equipment. With my ts-100 I can keep...
€ 1,17 | 10PCS LSA-05-9G Factory direct 3pins Reset Mini Leaf Switch with Triangle https://a.aliexpress.com/_EIMjQrp Does not seem like a...
Good, so now you have two 430, better start recording something!
300mA might be low on paper, but if the battery indicator still indicates higher than fresh batteries it still means it's providing enough voltage...
I made a few usb to Center negative barrel plug cables and use some old iPhone chargers(5v 1A), they work fine. Still, I think 400mah is enough...
I remember seeing a service manual with a service bulletin attached mentioning a revised board, with a different part for the headphone amplifier...
[img]
Did you check if the motor driver ic is getting voltage? there are a bunch of expected voltages noted around QM01 on the SM, some are going to the...
Yes, it’s printed with a resin printer, then some sanding is required to touch up here and there and a coat of paint.
Separate names with a comma.
