I bypassed CP101 and left channel works fine :) Than I decided bypass and CP201 too. As I understand MPX filter for records from FM radio and it...
I checked CP101 and @Deb64 I think you were right. I run 1kHz from my phone to line in and what I get: On line in contact R L...
I will try tomorow check CP101 and CP201 output pin. As I understand I need measure voltage between ground and 6 pin on CP 101 and CP201? Their...
@Deb64 thank you, can I use multimeter with true RMS instead oscilloscope? I don't have oscilloscope unfortunately :(
Hi @Deb64 I recently replaced the EQ modules too and there was an printed photo in the parcel how to solder it, and CP303 in a different position...
@Valentin thank you for great tutorial. Can I use this test tape for Dolby levels? It's 400Hz instead 330Hz in your instruction. Or it doesn't...
Can you share some photo or diagram where to solder diode and regulator?
@Deb64 is there a working method for protecting against over voltage and reverse polarity, maybe some schema or instructions? Since the CX20084 is...
@Deb64 Thanks a lot for your advice, I soldered 8 pin and it works :delighted: Manual speed control works to. But I can't understand how that pin...
Thanks will try it today.
This is working solution for replacing CX20084?
Hi, I have same speed issue as I understand the reason is CX20084 I can't get original one for replace, only found on aliexpress, will try to...
TPS-L2 and D6C
Hi, Valentin thanks for your guide on this forum, very helpful. I need little help, I carefully removed two flywheels and when I flip the device,...
My name is Vitaly, and I need some help for my first restoration :)
Separate names with a comma.
