Just revisiting this one as I get close to getting it out and repairing it - do you think a spot welder type gadget might work to secure this...
ok thanks guys, I will try some more cleaning. I guess I was trying to avoid taking the head out being nervous of adjustments needing putting it...
I assume a basic polish would require the head to come out? what's best method for polishing - dremel and soft cotton/wool buffing attachment?...
I edited initial post with better images. curious about this amber looking build up on the head - I've not seen that before, the only thing I...
Picked up a reasonable Panasonic model - and it's got either build up or some surface wear as seen in pic below, tried alot of rubbing with cotton...
Yes the post has tiny wiggle, barely noticeable - but I'm fussy lol. I pulled at the pully a fair amount before resorting to leveraging with tiny...
Thanks managed to get it off. I appreciate the tips @Valentin, I used some thin selotape, and put one facing upwards under the split washer and...
Hi After removing a melted rubber band of this WM-501 I noticed the pulley was stuck, I got it rotating with some encouragement by pushing with...
ah nice, those might work - can you confirm dimensions for me? I updated the original post with max size for the battery to fit - L52mm x W15mm x...
Hi @Valentin - do you mean so you can see the part numbers on these 2 IC's? [ATTACH]
@Emiel I hadn't spotted that post - is that pertaining to possible failure of drop down voltage components in the battery then letting the full...
I'd been looking to get a nice USB-C rechargeable Li-polymer battery - and eventually bought one off Aliexpress to check out the quality. Here are...
Separate names with a comma.
