As far as service manuals goes, these are rarely uploaded and in general doesn't make sense to upload them for 2 reasons: - those that are free...
Hello and welcome to the forum @Stefania ! Think it's worth taking some pictures of the device, box and accesories and add them to the forum....
Photos I take myself (which tend to be large) I resize to match the 2000pixels required by the forum and also compress it to be in the hundreds of...
Point is an incorrect adjustment of the RV601 can make the PLL loop unstable and create high W&F. When that is the case, the high W&F will go...
Turning the speed tune on disables the quartz lock (PLL), so it's more than just a speed change.
Don't use WD-40 for lubrication, ideally use watch oil. If that isn't available use a 5W30 engine oil instead. WD-40 is not designed for...
Does it exhibit the same W&F regardless of speed tune being set to on or off ?
I don't lubricate the autostop lever. As for the supply reel, set the height so it has ~0.05-0.1mm of play, main idea being it moves freely....
What are the W&F figures before/after ? Used these rubber tires and capstan ring for a long time and didn't have problems with it. Is there any...
To remove the PCB there are a couple of solder points you need to unsolder: - buttons area (there are 2 groups of 2 contacts); - motor board (near...
You need to remove the screws that hold the back cover (black) and then pull from the part near the battery door (where the sticker is). If the...
Interesting idea, if you can find the right head worth pursuing the project. Maybe worth asking some head manufacturers if they can make a custom...
I would trust a fresh tape recorded correctly way more than a factory one made 40+ years ago. All tapes have some tolerance, including the...
Yes remove the back cover and eventually soak the terminals in contact cleaner. The positive one comes together with a plastic piece on this...
Have to disagree on that. While it is true that the best calibration cassettes sold today are made on good home decks, that in and of itself does...
Remove the terminals and clean them with wire brush in a drill and/or sandpaper. Depends how badly the terminals are corroded, as it's not always...
The pinch roller it usually doesn't need, but the other rubber yes. All D6Cs I serviced are pretty noise due to hardened capstan ring and tend to...
@treynava1 Don't notice anything abnormal apart from something wet at the bottom of the roller (oil ?). The ebay link in post #5 is from...
How does the pinch roller and capstan look ? Seems at first glance that the roller is pulling the tape up/down, although the damage in the...
The capstan is indeed polished. Assuming the motor still runs and only tape stops, that's your problem. You need to etch the capstan with ferric...
Separate names with a comma.