Liquid type super glue is what I have used. But before you glue make sure you note the right orientation of the gear.
MIN level is also labeled AVLS, so the MIN setting does correspond to AVLS. Can be seen in this picture:...
I have the EX7 and in my opinion it's a good walkman as far as sound quality goes: output power is enough, low noise, good bass and treble...
Typically, most belt walkmans don't have specifications for w&f. The measured figure is indeed way too high, something around 0.2%-0.3% WRMS...
In regard to rubber gromets, if they're the standard o-ring type, I have used 10mm x 3.5mm (outer diameter x cross section) o-rings on Discmans....
Some of the values are indeed off. But the fact PLL is disconnected and battery voltage is not 3V will influence this circuit. I suggest changing...
Ask Tom Tom, he is likely to have spare parts. Want to add something myself. This part is likely breaking due to the fact it was removed...
The very thin white washers I think 3 are on the top and 3 on the bottom. Then there are 2 thicker ones, one on top one on bottom. Main idea is...
Repairing this motor is not simple, I would say one of the hardest ones out there. That's how it is with all coreless motors and these are used in...
Glad you found the thread useful. The TPS-L2 and WM-3 are good walkmans, contrary to what some people think. Very good build quality and even...
Reserved
This thread covers a problem with the clutch gear on the following walkmans: TCM-600, TPS-L2, WM-3, WM-D6, WM-D6C. Symptom of this gear failure...
@Bobbie Dixon From my understanding what you want to achieve is monitor the signal coming to your amplifier using the VU-meters of the deck. As it...
I got very good results with the PC202s I serviced, Dolby C decoding working exactly as it should. As already mentioned, capacitors aren't usually...
Dolby C indeed will not work well on this unit as-is. It will need calibration to work as intended, all PC202 and P202s I have serviced were off...
That line is indicating a magnetic fluxivity of 200nWb/m, which happens to correspond exactly with the ANSI Dolby level. Picture is taken from an...
Unfortunately this type of motor has no holes to keep the brushes spreaded apart. First, one has to remove that red plug in order to have access...
@Jehr It's to be noted I don't see this lubrication as a cure to wear or other motor problems, but rather as a maintenance item. Listening more...
That is unfortunate. More than likely this is not a lubrication issue, but something else wrong with the motor. But at the end of day, things like...
Separate names with a comma.
