@SoundBuzz The fact Q105 looks fine visually doesn't mean much. You need to check the signal path from point to point (with oscilloscope or...
Some DeckTech belts I did found to look a bit old, but they worked fine and w&f was very good. While the above mentioned ones will likely not...
It's way too much, you need to have 0.05-0.1mm of play. In other words there should be just enough play so there is no friction on the washers,...
Something in regard to testing these levers work correctly (before and after the cleaning/repair): push the bigger lever arm down and see if it...
@BusiG Watched the video, can't hear the solenoid. Right after you press play, the solenoid should engage (pressing play not shown in the video)....
Let us know how you find the belt #2. I had good experience with DeckTech belts and have used many of them. Please share the negative feedback...
If you move the pulley up and down, how much play do you have ? It is not normal for the shaft to pull very easily after reassembly. There may...
The laser emits some faint visible red light, but most if the emission is infrared. You should see the red light looking from an angle (don't look...
Especially the vias, then the traces and the least I would suspect are parts. What I would do is check all vias near capacitors (especially where...
If the device works when the 2 PCBs are separated you need to investigate why that happens. Something is either shorting from one board to...
Now you have to figure out what is causing the problem. As stated before, for easy check, you will need a cassette gauge. But visually you should...
Liquid super glue, you need just a small drop in the circled area.
Watch oil is what you should use. You sould not use grease. A pen type recipient like this https://www.ebay.com/itm/164185783921 is easy to use,...
Picture is visible now. This STOP button is made of 2 parts: - the exterior button itself (what you show in this picture); - the part that goes...
I edited the picture for clarity. What is marked 4 is the shaft + pulley. The type that drives a belt is called pulley, a spindle looks different....
Indeed no image, attach it again sometimes there are errors. The end of the black plastic part has 2 hooks, that is what keeps the button in...
The fact you hear sound when FF/REW means the amplifiers are not muted. You shouldn't hear anything during FF/REW, not even the noise floor of the...
There's no trick to install that button back, if it doesn't click back into place it means one or both of the 2 plastic hooks have either broken...
I was reffering to what is shown in second picture of post #2, which looks like it's the AC240 measured but I may be mistaken. My point with LDO...
The FG wires do not matter how are soldered. If you can, take additional pictures with the repair and post here. The fact motor seemed like it...
Separate names with a comma.
