The voltage on pin 5 should be 1.65V or somewhere close. If it is low then check C606 first; it may be leaky or short.
PM sent to @Cassette2go.
I have labelled the bridge on the photo. Note that the white wire from the two core screen cable, from the speed tune switch and pot, should be...
The only other capacitor which I can suggest is C608 (3.3uF / 16V tantalum). I had one of these which had failed on a SMD D6C last year. In this...
It sounds as if you have a capacitor problem. When you have the speed tune switch set to "On", does it start at the correct speed and stay at the...
You should check the ESR of C601, C602 and C603. These are the electrolytic capacitors on the FG amplifier circuit. If these have gone high ESR...
@retrocode.kr Good luck. Take care and take your time.
It is also worth removing the remain of the potting from under the pins of the CX20024. You may need to put the CP602 back into some acetone to...
From my measurements I believe the values of the capacitors shown are: 1 - 2n2 2 - 180pF 3 - 2n2 4 - 10nF 5 - 10nF 6 - 3n3 The missing diode was...
Hi and welcome to the forum. You will find plenty of like minded and knowledgeable folk on here.
Hello and welcome to the forum. You will find plenty of like minded and knowledgeable folk on here.
Hello Lee, and welcome to the forum. You will find plenty of like minded and knowledgeable folk on here. Your D6 was a nice example to work on...
The D6C has Dolby C and a line out as well. The D6 and D3 also have line outs but don't have Dolby C. They all sound very good but my personal...
Hi and welcome to Stereo2go. Good luck with getting the Aiwa working. It will be a great, and very rewarding, project for you and the kids. You...
Hello and welcome to Stereo2go.
Hello fellow Deb and welcome to Stereo2go.
Hi and welcome to Stereo2go.
Hi and welcome. You will find plenty of knowledgeable folk on here who can help out.
BE VERY CAREFUL HERE! The DC2 uses the CX20084 motor control chip, which is easily destroyed by switch mode power supplies, as well as a reverse...
@Hook91 I have just sent you a message.
Separate names with a comma.