soooo I put the D90 laser in the D22 just so everything can go back together nicely and would you know it the D22 powered on lol! laser still dead...
Yeeeaah so…. I haven’t recapped anything on the D90! That was my last resort, I’ve seen you D90 repair post but does it list specific caps to buy?...
Do you have a contact or email for Kaosun? I might get a quote from him.
Hi all, Ok so I have a D90 and it was doing the “00” spin a few times and then turns off situation. So I figured ok this is laser. I also...
oh man that’s a lot… i managed to check the mA to see if it matched what’s on the laser label (31.7mA) and it was 30mA.. so pretty close but lower...
Nice one mate, man I wish my D90 had obvious capacitor issues, no idea where I should start and if cap replacement is going to be just a waste of...
Does anyone have the shopping list for caps for the D311? I also have this model and doesn't seem to want to play a disc, just the dreaded 00....
Hi there Recaptcha, Do you have the shopping list for the caps you bought from Mouser? I would greatly appreciate it. I have recently acquired a...
I think you'll be ok... just build up the solder there and it'll connect. Just make sure nothing bridging that shouldn't, get some solder mask.
Sounds like a proper power management board needs to be created to sit inside the new battery, so it can use all the capacity and also...
5.7 hours is quite impressive regardless, are you able to share the link of the battery pack in your pictures that achieves this? Do the...
Does anyone have a shopping list of capacitors to buy to replace on say the D-90?
I had these symptoms on my D90 (albeit I still need to clean the laser) before I made sure the middle gear was loose enough. Could be the metal...
Oh ok the front buttons are failing? Two things, you can spray some isopropyl on the front problematic buttons and hope it gets in and then click...
I would say that most likely the laser is getting tired if it struggles to play it but others do. Same thing can be detected when a player only...
Hey bud ok so once you have all the screws (4) you can see out, you need to work the unit out of the shell starting with the back end.. then you...
I love this unit, I once owned 5 of them! Now down to two, and I have the full INTEC205 stack (MD, CD, TAPE, AMP + EQ). I’ve been in and out of...
Hi everyone, Read a lot of very helpful information on this forum and finally had some questions of my own. I’ve been collecting audio...
Separate names with a comma.
