Glad to hear you got to the last step ! For current measurement, you need to put the multimeter in series with the motor. See picture attached,...
Do you get a resistance reading between the white and red wires ? Try to rotate the back plate with brushes and see if in a different position the...
For most music genres out there, indeed you won't notice the difference between 0.2% and 0.3% WRMS, the value at which it becomes really...
Most of the capacitors operate at a voltage of 1.1V, so any rating of 2V or higher is just fine. Main concern here is the dimension not the...
The W&F result is good in my opinion, especially considering there was nothing done apart from swapping the belt. In regard to the belt's impact...
Am talking about the gear not being totally flipped, because it can be installed on both sides of the metal disc but only one side is correct.
Liquid type super glue is what I have used. But before you glue make sure you note the right orientation of the gear.
MIN level is also labeled AVLS, so the MIN setting does correspond to AVLS. Can be seen in this picture:...
I have the EX7 and in my opinion it's a good walkman as far as sound quality goes: output power is enough, low noise, good bass and treble...
Typically, most belt walkmans don't have specifications for w&f. The measured figure is indeed way too high, something around 0.2%-0.3% WRMS...
In regard to rubber gromets, if they're the standard o-ring type, I have used 10mm x 3.5mm (outer diameter x cross section) o-rings on Discmans....
Some of the values are indeed off. But the fact PLL is disconnected and battery voltage is not 3V will influence this circuit. I suggest changing...
Ask Tom Tom, he is likely to have spare parts. Want to add something myself. This part is likely breaking due to the fact it was removed...
The very thin white washers I think 3 are on the top and 3 on the bottom. Then there are 2 thicker ones, one on top one on bottom. Main idea is...
Repairing this motor is not simple, I would say one of the hardest ones out there. That's how it is with all coreless motors and these are used in...
Glad you found the thread useful. The TPS-L2 and WM-3 are good walkmans, contrary to what some people think. Very good build quality and even...
Reserved
This thread covers a problem with the clutch gear on the following walkmans: TCM-600, TPS-L2, WM-3, WM-D6, WM-D6C. Symptom of this gear failure...
@Bobbie Dixon From my understanding what you want to achieve is monitor the signal coming to your amplifier using the VU-meters of the deck. As it...
Separate names with a comma.
