Do you have both versions ? Is there any difference inside ? (at least on the visible part of PCB) I have never seen the one with "Silent...
You can edit posts by using the EDIT button at the bottom of the post. As for the mechanism, I have to admit I don't think I have seen this type...
I don't think that number represents anything. From what I know, the hall sensor type mech is not that common and I think there's only one type of...
The 3 positions on the cam gear can only be: STOP, FWD (forward play), REV (reverse play). FF and REW work just by rotating the motor with cam...
What is depicted in the service manual is not useful, it only shows the parts without explaining how the mechanism works. The floppying gear...
A datasheet has never been published for sure, as it's a proprietary design (as all CX type ICs). But the internal block diagram is available in...
@Mister X Do you have some reference to the info you posted about the model ? By the way, what is the model number of this Technics ? M1 ?
Ok, I understand now. It looks like the head may not make a connection to the head preamp. Another thing to test: move the EQ sliders all the way...
Is this the one that appeared on TechMoan's video once ? It looks like it, I remember seeing something very similar to this unit and it remained...
I don't quite understand what you mean. You say you hear only noise when you put the contact between head jacks and port ? What are you reffering...
@Flops Those 2 metal brackets are for mechanical rigidity of the jacks. Although you should put them back to protect the jack and PCB connection,...
@Flops The belt routing is not correct. It should not go over the supply reel at all. Only on the motor, idler and 2 flywheels. There is probably...
Thanks for the serial number ! If there is no clicking sound, there is no breaking in the center gear, meaning you have a full plastic gear, not a...
@CDV I put 2 pictures explaining what is happening. The idea is the middle plastic bushing (with the center hole on which the gear rotates on) and...
Just cheked the WM-3 in my collection: the belt routing is correct as its shown in pictures, however my motor turns counterclockwise. So the...
That washer doesn't look like it would fit where you put it in the picture, because the center hole is too large. If it were to sit below the...
Are you sure your motor wires are soldered correctly ? Maybe your motor is turning backwards. When belt is installed backwards, the takeup reel...
Probably no because of 3 simple reasons: 1. The original gear was molded onto the metal disc, meaning you will only be able to buy the complete...
@Marty That's a cool looking walkman. Given the capacitors on this model have leaked onto the PCB, it is likely that corrosion exists on the PCB...
@radionick Indeed you are right about the internal regulator, it comes out at pin 5 as well, I did not pay enough attention. In this case, it's...
Separate names with a comma.
