There were actually 2 walkans that featured dBx NR: Panasonic RQ-J20X and TEAC PC-7RX. Also the Marantz PMD430 portable recorder featured dBx both...
@Kiwinut Don't know what you mean by "the latest" as what is used now on, for example, Tascam 202 mkVII is not actually Dolby. Generally speaking...
I wrote a tutorial about this walkman: https://stereo2go.com/forums/threads/jvc-cq-1k-restoration.6431/ 1. Bad caps seem likely to me based on...
No, I was reffering to the 3 versions of the heads: pointy, 35711 and 35712 permalloy. Will edit the wording for more clarity.
The 2 service supplements only show changes in the electronics: - Supplement 1 (January 1985) is about replacing the Dolby ICs from CX20068 to...
I lap the heads myself. In regard to serial number, don't know it out of my head but there are a couple of threads about it. Think it was indeed...
I assume the 2 caps that were leaky are the output coupling ones. What do you mean exactly by "the sound fades away" ? Is there a gradual...
100uF gives a corner frequency f(-3dB) of ~50Hz with a 32Ω load, without considering R152 or amplifier's own output impedance (but this is low)....
Bias frequency on D6C is indeed 65kHz.
The 35711 head has around 120mH @ 1kHz. As far as the general difference between amorphous and permalloy, it really depends on the particular...
The C138 I'm reffering is the one going to pin 20 of Dolby IC, as I was reffering to just 1. The output coupling ones get replaced in pair if they...
Maximum height of D6C capacitors depends on where each cap is positioned, as in some places there is space for ones taller than the original. For...
Here is the tutorial: https://stereo2go.com/forums/threads/sony-wm-d6c-no-rewind-ff.4687/
AIWA PL30/303, PX30/PX303, PX50/505, PX900, JX30/303, PL50/505, HS-F505, HS-JL30/303, HS-PL55/555, HS-F50/F505 These units are very similar,...
Panasonic RQ-P580/RQ-P500/RQ-P515/RQ-P525 (uses 3-phase brushless motor) Panasonic RQ-JA150/RQ-JA155/RQ-JA158/RQ-JA160/RQ-JA170/RQ-JA180 (uses DC...
I typically don't replace capacitors just because they're old. Rather, I prefer measuring them on LCR meter and compare with typical parameters of...
This model uses a 0ZM mechanism, so things like re-lubrication, bent pinch roller holding pins and bent head bridge are to be expected. They're...
You can find the PCB diagram here: https://www.petervis.com/manuals/sony-wm-d6c/pcb-and-wiring.html It's in black and white, but the traces are...
In regard to the diode I attached a picture. The simplest way I see is remove that jumper wire and add the diode there (it may require enlarging...
If you want protection from both DC in jack and batteries, you will have to cut quite a few traces. In my opinion putting all 4 batteries...
Separate names with a comma.
