Please add a link to the new hex reatiners on the thread, for reference. The up/down movement of the reel itself (the part that engages with the...
Yes, drill it so it's same diameter as the major spline diameter on the shaft, can even be a bit larger since the glue will fill the extra space....
The only way of repairing is enlarging the hole with a drillbit so it's no longer a press fit, then glue the gear to the shaft while keeping it...
Managed to find some pictures of an older repair of KT-AS1, which may be enough to post a thread later on. You can see in picture attached the...
Thanks for pointing it out ! Was actually surprised when I saw the video, but thought maybe he was lucky. Now it becomes obvious his also has the...
Ok, understand now about the dimensions. Thanks for sharing the drawing ! Tire height and hub flange OD are only important in case only the tire...
First of all, have the reel gears and retainers been checked ? It's a common problem on these. Recently seen a NOS RS1 on TechMoan's channel that...
There are some cracked gears, known issue on this model. Cracks are visible, see picture attached. New gear set is available here:...
The information in the service manual and those 2 threads are pretty clear. There are 2 outpus: 2.4V and 3.5V and both should be present when...
My mistake, I wanted to say auto-stop. Edited the post. Also, no need to quote previous posts. Rather type in box below and use the "Post Reply"...
If gear arm has been bent too much, it will result in engaging both reels at the same time after some point. Rather than bending, I recommend...
Indeed C110 is in parallel with C126 and has nothing to do with the logic control. Don't see how adding that capacitor could make the logic...
First thing to check is takeup torque by feel. If clutch isn't slipping, but rather the small idler slips auto-stop won't engage. Also look at the...
The REW problem is caused by either the center gear going too low or the FF gear sitting too high. You need to investigate which one is causing...
There are 2 threads about this already: https://stereo2go.com/forums/threads/sony-wm-f701c-f707-r707-no-power.10132/#post-82425...
Note there is a black lever that needs to go into the white plastic slider. You need to remove the plastic slider again and install it with that...
Can you mark on the schematic where is this C110 ? At first glance can't find it. Would make sense the recording models are different, since...
As a suggestion for others reading the thread, the magnetic part of the clutch should be removed when glueing the new gear. This way even if the...
Yes, you should be able to measure the solenoid's coil resistance. If it's open circuit, solenoid is defective. Let us know what happens with the...
Separate names with a comma.
